Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterDoorKing Gate Installation in Beverly Hills: What to Know First
DoorKing gate installation in Beverly Hills typically runs $1,800 to $6,500 depending on whether we’re setting a new operator on an existing gate, building a full driveway gate from scratch, or retrofitting an older DoorKing system that’s finally given up. We’re an independent DoorKing service provider, not a factory shop, and most jobs wrap up in two to five days once materials land. You’ll get a written price before any work starts, and that price doesn’t change at the door.
This page is for homeowners in Beverly Hills who already own a DoorKing opener or are weighing one against other brands. If your gate is sagging, grinding, or refusing to close, call us at (559) 844-6989 and Hal or one of his crew will walk you through what you’re looking at.
How DoorKing Products Fail - and How We Fix Them
DoorKing builds solid operators, but every brand has its patterns. Here’s what we actually see in Beverly Hills driveways.
- DoorKing 9150 slide gate operators and the limit switch drift. The 9150 line has been a workhorse on Beverly Hills sliding gates for years, but the mechanical limit switches wear and drift over time. The gate starts stopping six inches short or banging past the stop. We don’t just re-set them; we pull the cover, clean the actuator assembly, and replace the switch if it’s worn. Cheaper shops will adjust and leave, and you’ll be calling again in two months.
- DoorKing 6002 swing gate operators and capacitor failure in the heat. Beverly Hills gets real sun on those southwest-facing driveways off Sunset, and capacitors in the 6002 series don’t love the prolonged heat. The symptom is a gate that hums but won’t move on the first try, then works fine an hour later. That intermittent behavior is almost always a capacitor degrading. We replace with OEM or a quality equivalent, not whatever’s on the truck that week.
- DoorKing 9000 series and the chain tension creep. On longer driveways the chain stretches, and a lot of installers never check it. The gate gets louder, the operator strains, and the sprocket wears prematurely. We check chain sag and tension as part of any DoorKing install or service call. That’s the difference between an operator that lasts fifteen years and one that dies in five.
- Photocell and safety loop problems on older DoorKing systems. Beverly Hills gates built in the early 2000s often still run the original photo eyes and loop detectors. When the gate reverses for no reason or refuses to close, nine times out of ten it’s a failing photo eye or a loop that’s lost its signal, not the operator itself. We test the loop frequency and the photocell alignment before touching the motor. Replacing a $40 photo eye beats replacing an $800 operator, and we’d rather tell you that.
- The “factory reinstalled it wrong” repair. We get calls from Beverly Hills homeowners who had a DoorKing installed by a chain or a handyman, and the gate never quite worked from day one. Wrong chain tension, limit switches never calibrated, safety loops skipped entirely. Hal opens the cover and just shakes his head. We redo the install properly, and it’s usually fixed same day.
Our DoorKing Gate Installation Process
Here’s what a DoorKing job looks like when we do it.
- 1
You call, a person answers. Not a voicemail, not a call tree. We ask what the gate’s doing, what brand you have, and when you need it looked at. Tell me what it’s doing and I’ll tell you what it needs - no guessing, no runaround.
- 2
We come out and look at the whole gate. Operator, hinges, post set, chain or arm, safety loops, photo eyes, the concrete pad. A DoorKing operator doesn’t fail in a vacuum. If the gate sags, the operator’s working twice as hard, and fixing only the motor is a temporary patch.
- 3
You get a written price before we touch anything. Exact number, labor and parts separated, no “we’ll see once we open it up” games. That price is binding. If we find something else, we stop and call you first.
- 4
Parts decision: OEM versus quality aftermarket. For warranty-sensitive items like control boards and gearboxes, we lean OEM because it keeps your DoorKing serviceable by the factory if anything goes sideways later. For wear items like chains, belts, and photo eyes, a good aftermarket part often does the job for less money. We’ll show you both options and let you decide.
- 5
Installation, calibration, and safety testing. We mount it, wire it, set the limits, tune the torque, and test the safety reversal and obstruction sensors three times minimum. Then we run the gate through twenty full cycles and watch for drift.
- 6
You walk the gate with us before we leave. We show you the manual release, the test button, and what the lights mean. The job’s backed by our 90-Day Done Right Promise in writing. If it’s not right when we leave, we make it right.
What DoorKing Gate Installation Costs in Beverly Hills
Straight numbers, because you should know before you call.
| Job | Typical Range |
|---|---|
| DoorKing operator install on existing gate (slide or swing) | $1,800 - $3,200 |
| Full sliding driveway gate with DoorKing operator | $4,200 - $6,500 |
| Full swing gate (single) with DoorKing operator | $3,800 - $5,600 |
| Double swing gate with two operators | $5,500 - $7,800 |
| Retrofit an older DoorKing with new controls and safety edges | $1,200 - $2,400 |
What moves the price: driveway width and gate weight, concrete condition, whether we’re pulling new power from the panel or tying into existing conduit, and whether safety loops need to be cut and sealed. Beverly Hills driveways on the flats are usually straightforward; hillside properties off Coldwater or Benedict Canyon with long runs and tricky drainage add time and materials. You’ll always get a line-item quote you can read, agreed before we start. Call (559) 844-6989 for an exact number on your gate.
Why Beverly Hills Homeowners Call Gatewood Fence & Gate for DoorKing Work
Hal Gatewood started fixing gates in and around Beverly Hills in 2001, and he’s still the one who answers the phone. Our address is published, our license is public, and Hal’s name is on the shop and on every invoice. The 90-Day Done Right Promise isn’t a marketing line; it’s stamped in writing on your job. Call with a problem inside three months and one call brings him back, no runaround.
We work on DoorKing every week, and we also know the other stuff sitting in Beverly Hills driveways: LiftMaster, Mighty Mule, Ghost Controls. When we say we know a brand, we mean we’ve repaired enough of them to know where they fail and why. And if you’re on the fence about whether a DoorKing is right for your property, we’ll tell you straight, because selling you the wrong operator is how you end up on a first-name basis with a repair shop. We’d rather do the job once.
FAQs
Yes. We install, service, and repair DoorKing slide, swing, and pedestrian gate operators throughout Beverly Hills as an independent service provider. We’re not tied to DoorKing corporate, which means we work for you, not the factory.
Most operator-only installs happen within a week of the quote. Full gate builds take longer because material has to be fabricated or ordered, and we’ll give you a window in writing when we quote it. If your gate is down and you can’t close it at all, that’s an emergency, and someone will be there fast.
If it’s repairable for less than replacing it makes sense, that’s what we recommend. Hal’s rule is simple: if the case, motor, and gearbox are sound, we fix the board, limits, or sensor. If the gearbox is chewing itself up and the motor’s burning out, you’re paying for a new one anyway, and we’ll tell you that before any money changes hands.
If your operator is still under factory warranty, you’re better off with OEM parts for covered components. We’ll verify your warranty status before ordering, and for critical electronics we default to OEM regardless. For mechanical wear items, a quality aftermarket part is often the better value, and we’ll show you the difference before you choose.
Every time. A DoorKing operator without working safety loops and photo eyes is dangerous and illegal in Beverly Hills. We cut loops, pull the wire, align the photo eyes, and test the obstruction reversal before we leave. That’s not an add-on; it’s the job.
Get Your DoorKing Gate Installed Right
If you’re in Beverly Hills and your DoorKing gate needs installation, retrofit, or an honest diagnosis, call (559) 844-6989. A live person answers, day or night. We’ll schedule a visit, give you a written price, and do the job the way we’d want it done at our own place. No trip charge inside the county, free second opinion on any written estimate, and the 90-Day Done Right Promise on every job.
Written by Hal Gatewood, Owner, Gatewood Fence & Gate at Gatewood Fence & Gate, serving Beverly Hills and nearby areas.